Fairbanks InterAct FB3000 Series - Manual (Page 108)

50772 108 12/04 Issue # 2
Reset Reset the data terminal
Unattended Put terminal in unattended mode
GetWeight Get a weight from the unattended terminal
GetWeight Get another weight
GetWeight Get another weight
GetWeight Get another weight
Attended Put terminal in attended mode
Enable Repeater (Single Command)
When this box is checked, the command entered in the Data to Send box will be sent repeatedly to
the RTSA.
Timer Interval (msec)
Enter the time interval between commands for the Loop and Repeater options.
Units
This field is not used.
Data Received
This field contains the message received from the RTSA in response to a command.
Data to Send
Enter a command to send to the RTSA.
Attended Place RTSA in attended mode
Unattended Place RTSA in unattended mode
DriveAhead Drive ahead command
DispMsgN Display message on line N. This command is immediately
followed by the message to display.
Error Error command
GetCode Wait for and return driver entry
GetWeight Get current weight
MoreMatrls Ask driver if there is another material for this ticket
OpenGate A valid truck id has been entered, open gate
PrintLine Print ticket line
PrintEnd Done printing ticket
Reset Reset RTSA
SetPrompt Set drive prompt
Rezero Zero scale indicator
Check Sum
The RTSA returns the sequence number for the command to which it is responding.
Send Button
Click this button to send a single command or to begin the command loops.