Teledyne GFC-7001T - Trace CO Analyzer - Manual (Page 77)

Getting StartedTeledyne API – Model T300/T300M CO Analyzer
Teledyne Analytical Instruments 77
SETUP X.X RANGE MODE:SINGL
SNGL DUAL AUTO ENTR EXIT
SAMPLE RANGE=50.0 PPM CO= XX.XX
TST> CAL SETUP
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SETUP X.X RANGE CONTROL MENU
MODE SET UNIT DIL EXIT
SETUP X.X RANGE: 50.0 Conc
0 0 0 5 0 .0 ENTR EXIT
SETUP X.X CONC UNITS:PPM
PPB PPM UGM MGM ENTR EXIT
SETUP X.X RANGE CONTROL MENU
MODE SET UNIT DIL EXIT
SETUP X.X RANGE CONTROL MENU
MODE SET UNIT DIL EXIT
Verify that the MODE
is set for SNGL.
If it is not, press
SINGL ENTR.
Press EXIT as
needed to
return to
SAMPLE
mode.
Verify that the RANGE is
set for 50.0
If it is not, toggle each
numeric button until the
proper range is set, then
press ENTR.
Verify that the UNIT
is set for PPM
If it is not, press
PPM ENTR.
D ILUTION R ATIO S ET U P
If the dilution ratio option is enabled on your GFC7001T/GFC7001TM Analyzer and
your application involves diluting the sample gas before it enters the analyzer, set the
dilution ratio as follows: