Teledyne GFC-7001T - Trace CO Analyzer - Manual (Page 123)

SetupTeledyne API – Model T300/T300M CO Analyzer
Teledyne Analytical Instruments 123
I MPORTANT I MPACT ON R EADINGS OR D ATA
Before performing this procedure, make sure that the AUTO CAL for each
analog output is enabled. (See Section 5.9.3.3).
I
MPORTANT I MPACT ON R EADINGS OR D ATA
Manual calibration should be used for any analog output set for a 0.1V
output range or in cases where the outputs must be closely matched to
the characteristics of the recording device.