beautypg.com

Password security for serial remote communications – Teledyne GFC-7001T - Trace CO Analyzer User Manual

Page 191

background image

Remote OperationTeledyne API – Model T300/T300M CO Analyzer

Teledyne

Analytical

Instruments

191

8.4. PASSWORD SECURITY FOR SERIAL REMOTE

COMMUNICATIONS

In order to provide security for remote access of the GFC7001T/GFC7001TM, a
LOGON feature can be enabled to require a password before the instrument will accept
commands. This is done by turning on the SECURITY MODE (Mode 4, Table 6-1).
Once the SECURITY MODE is enabled, the following items apply.
 A password is required before the port will respond or pass on commands.
 If the port is inactive for one hour, it will automatically logoff, which can also be

achieved with the LOGOFF command.

 Three unsuccessful attempts to log on with an incorrect password will cause

subsequent logins to be disabled for 1 hour, even if the correct password is used.

 If not logged on, the only active command is the '?' request for the help screen.
 The following messages will be returned at logon:
 LOGON SUCCESSFUL - Correct password given
 LOGON FAILED - Password not given or incorrect
 LOGOFF SUCCESSFUL - Connection terminated successfully

To log on to the GFC7001T/GFC7001TM Analyzer with SECURITY MODE feature
enabled, type:

LOGON 940331

940331 is the default password. To change the default password, use the variable RS-
232_PASS issued as follows:

V RS-232_PASS=NNNNNN

Where N is any numeral between 0 and 9.