Teledyne GFC-7001T - Trace CO Analyzer - Manual (Page 136)

SetupTeledyne API – Model T300/T300M CO Analyzer
Teledyne Analytical Instruments 136
To activate the TEST Channel and select the CO MEASURE function, press:
SAMPLE RANGE=50.0 PPM CO= XX.XX
TST> CAL SETUP
DIAG TEST CHAN:NONE
PREV NEXT ENTR EXIT
DIAG SIGNAL I/O
PREV NEXT ENTR EXIT
DIAG TEST CHAN OUTPUT
PREV NEXT ENTR EXIT
Continue pressing NEXT until ...
Toggle to scroll and
select a mass flow
controller TEST
channel parameter. DIAG TEST CHANNEL:CO MEASURE
PREV NEXT ENTR EXIT
EXIT discards the new
setting.
ENTR accepts the
new setting.
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG EXIT
SETUP X.X ENTER PASSWORD:818
8 1 8 ENTR EXIT
Toggle these
buttons to enter
the correct
PASSWORD.
5.10. SETUP MORE  ALRM (OPTION): USING THE GAS
CONCENTRATION ALARMS
The GFC7001T/GFC7001TM includes two CO concentration alarms if OPT 61 is
installed on your instrument. Each alarm has a user settable limit, and is associated with