Luminex MAGPIX Installation and Hardware User (IVD) - Manual (Page 38)

Luminex IVD MAGPIX Hardware Installation and User Manual
26
FIGURE 35. The Hard Power Switch
3. When you are ready to begin testing, turn on the soft power switch on the front of
MAGPIX. The blue LED in the hexagonal window lights up as confirmation that the
power is on. MAGPIX requires approximately 45 seconds to start up.
NOTE: The soft power switch activates and deactivates the unit.
FIGURE 36. The Soft Power Switch
4. After MAGPIX is powered on, use the software to eject the tray carrier to put the off
plate reagent block in place.