Liquid Controls LCR 600 Setup & Op - Manual (Page 9)

9
fn box
The Fn command (on the up arrow button) provides a
set of additional characters and commands that can be
entered in a field edit box. The symbols on the left side
of the Fn box are commands. The symbols on the right
side are characters.
to activate an fn command or insert an fn
character:
1. Tap the Fn button twice to bring up the Fn box.
2. Using the
 and  buttons, move the highlighted cursor
to the desired command or character
3. Press the EntEr button to accept the highlighted
command or character.
fn commandS

Moves cursor to the farthest left position

Moves cursor one space to the left

Moves cursor one space to the right

Moves cursor to the farthest right position
↔
Insert toggle
↕
Upper/Lower case toggle
∆
Deletes character above cursor
✼ Deletes entire field
IntroductIon - lcr 600 InStrumentS and controlS
multItap functIonalIty
While a field edit box is on the LCR 600 screen, the
alphanumeric buttons and the down button can be used
to enter characters in the field edit box. The character
entered into the field edit box depends on the number of
times the button is pressed successively, similar to text
messaging on a cell phone.
Text Buttons
Navigation Buttons
Alphanumeric Buttons
Fn Button
Display Screen with Fn Box
Fn Box
Press the

button to backspace in
a field edit window