Liquid Controls LCR 600 Setup & Op - Manual (Page 24)

24
SyStem Setup
SyStem Setup 1
Meter Id:
(fE)
c
The identification number of the meter the LCR 600 is
mounted on. If the LCR 600 is installed in a multiple-meter
system, it is important this number be unique. The number is
printed on the calibration/diagnostic ticket. LC recommends
entering the meter’s serial number to ensure identification.
LCP Node Address: (fE)
c - u
Node address used by a host application, like the DMS i1000,
to communicate with the LCR 600.
Unit of Measure: (LB)
c
The unit of flow measurement.
Gallons • Litres • Cubic M • Lbs (pounds) • Kgs • Barrels • Other
decimal digit: (LB)
c
The decimal place of volume measurements shown on the display and printed tickets.
Hundredths • Tenths • Whole
Residual Processing: (LB)
c
The treatment of excess decimal places when displaying and printing volume measurements
Round
according to one half of the least significant digit
Truncate disregards the excess digits
Flow Rate Base: (LB)
c
The time unit of the measured flow rate.
Per Second • Per Minute • Per Hour
Flow direction: (LB)
c
The direction of flow through the meter. If the LCR 600 is counting in reverse (decreasing numbers), select the
opposite Flow Direction.
<− • −>
Printer: (LB)
c
The type of printer connected to the LCR 600.
ePSON NewFontB EPSON 200 Roll and EPSON 220 Roll
ePSON NewFontA EPSON TM-T88iii
ePSON OldFontA EPSON 290 Slip and EPSON 295 Slip
ePSON OldFontB EPSON 300 Roll
OKIdATA ML184T OKIDATA ML184T
BLASTeR Cognitive Solutions Thermal Printer.
l - locked
u - unlocked
c - Weights & measures calibration
p - Stop/pause
f - factory
Security clearance
fE - field Edit Box
LB - List Box
field type