Liquid Controls LCR 600 Setup & Op - Manual (Page 6)

6
IntroductIon - lcr 600 InStrumentS and controlS
red Selector Switch
The LCR 600 red selector switch, located at the bottom left of the LectroCount LCR 600, has five positions. The
selector switch’s primary purpose is to control everyday delivery and print functions. Functions include opening and
closing the control valve in order to start and stop deliveries and prompting the printer to print delivery tickets and shift
tickets.
the fIve poSItIonS on the Selector SWItch
Run - opens the control valve to begin a delivery
Stop - closes the control valve to pause a delivery
pRint - ends a delivery and prints a delivery ticket
Shift pRint - ends a shift, prints a shift ticket, and resets
shift data in the LCR 600
Calibration position - allows access to calibration
configuration settings.
Red Selector Switch
Six O’clock Calibration Position
calIbratIon poSItIon
The red selector switch also provides a secure
calibration position. When in the calibration position, the
LCR 600 may be used to calibrate the meter and enter
sensitive Weights & Measures data.
To turn the selector switch into the six o’clock calibration
position, the LCR 600’s switchplate must be removed. To
take off the switchplate, remove the four screws holding
it in place. If the LCR 600 has been previously calibrated
and approved by Weights & Measures, you will need to
remove the lead seal and the wire threaded through the
switchplate screws.
Selector Switch & Seal
LCR 600
LCR 600 without Switchplate