Section 8, Pc850 synchronize bases, Synchronize base station settings – Clear-Com BS850 (Last time buy) User Manual
Page 46

43
Synchronize Base Station Settings:
You can synchronize settings for the Beltpacs in cascaded Base configuration of the PRO850 System
from the Configure tab>Sync Beltpac Settings with Slaves box> System>Sync Bases path as
shown below:
To configure synchronized base station settings, press the Synchronize Master’s Beltpac Settings
with Slave bases
button.
NOTE:
This only pertains to systems with Master and Slave base stations. All Beltpac settings are
configured in the Master base station. Synchronizing the Slave bases will cause all Beltpac settings
from the Master base station to be transferred to the Slaves.
This function also serves as a quick check of the communication between the Master and Slaves. If
there are any communication problems, an error message is displayed in the status window under the
button. The message will indicate the synchronization was successful, or will indicate which slave
failed to respond.
SECTION 8. PC850 SYNCHRONIZE BASES