Clear-Com BS850 (Last time buy) - Manual (Page 12)

9
PRO850 Other Features:
A feature can be selected for scanning through all available intermodulation-free frequency groups to
automatically configure the system for the best available set of frequencies. Specified frequencies can
be saved for quick recall.
The PRO850 can be configured for fixed power output levels or automated output power control. With
the automated feature selected, the PRO850 senses how far a Beltpac is from the base and
automatically determines at what power level the Beltpac should be operating, eliminating base
receiver overload and increasing Beltpac battery life.
Two hardwired intercom channels provide simultaneous 2-wire and 4-wire operation.
The base headset interface automatically detects and accommodates dynamic or electret
microphones. It provides direct access to intercom channels 1 and 2, Beltpacs only or all channels.
Any Beltpac button can be configured to activate the base paging relay and, at the same time, audio is
routed to the paging output.
The base can be configured to initiate an alert for various conditions, including low battery condition
or a Beltpac alert-button press.
The PRO850 is fully compatible with RTS
® and Clear-Com ® hard-wired intercom systems.
With PC850 software, the base and Beltpacs can be configured on a PC, and configuration settings can
be saved to files. An RS-232 serial port on the rear panel of the base provides PC interface capability.
Beltpacs can also be configured using a Palm-OS PDA with the optional PDA850 software.
The base can operate from a standard 12-14VDC power source or from an external DC source such
as a vehicle electrical system for mobile operation.
NOTE: For additional PRO850 Equipment Data and Operation, see Sections 14 and 15.