Clear-Com BS850 (Last time buy) - Manual (Page 26)

23
Base Station Auxiliary Input Level:
You can change the Auxiliary input level using the slider from the Configure tab >Edit Base
Configuration
box >Base>Config>Input Level section. Any change made here will be reflected in
the Monitor Input display for Aux Input.
Base Station Microphone Input Level:
You can change the headset microphone input level using the slider from the Configure tab >Edit
Base Configuration
box >Base>Config>Input Level section. Any change made here will be
reflected in the Monitor Input display for the Mic Input.
Base Station Intercom Input Levels (Ch1 & Ch2):
You can change the Channel1/Channel2 input levels using the slider from the Configure tab >Edit
Base Configuration
box >Base>Config>Input Level section.
Base Station Name:
You may assign an identifying name or number of up to nine characters to the base from the
Configure
tab >Edit Base Configuration box >Base>Config>Base Identifier section.
To enable the display of the name as a screen saver when other operations are not being performed,
check the Enable Screensaver box. The base name will be displayed a few minutes after no button
presses have occurred.