beautypg.com

Base receiver settings, Base station receiver frequency – Clear-Com BS850 (Last time buy) User Manual

Page 29

background image

26

Base Receiver Settings:

You can set up the base station receivers from the Configure tab >Edit Base Receivers box
>Base>Receivers

as shown below:


As shown above in the Enable column, you can select a receiver to be Off or On. You can also use
the Audio Level slider to adjust receiver audio levels and the receiver squelch.

NOTE:

The amount of gain applied here to receiver audio level at input of DSP will also be shown on

the Monitor Input display screen for that receiver.

Base Station Receiver Frequency:

As shown above in the Configure tab >Edit Base Receivers box >Base>Receivers, you can click
on the Frequency field of the table to reveal the frequency editing form. Click on the Group to select
frequencies P1 – P4, S1 – S4 and T1 – T4 (presets in the system that cannot be changed).
Frequencies U1 – U16 can be adjusted and saved by the user. If you select a user frequency, U1 –
U16, move the cursor to the frequency box and use the up and down arrow buttons together with the
control knob to select a frequency. User frequencies can be selected in 25 kHz increments.
You must click on OK to save your frequency changes.

For multiple Beltpacs to share a receiver frequency (PTS), check the PTT Shared box. If you turn on
PTT Shared

you must also set the Beltpac transmitters to PTS mode (See page 33).

NOTE:

Frequencies within the same group (P, S or T) are compatible with each other and free of

intermodulation. Never choose frequencies closer to each other than 375 kHz.

This manual is related to the following products: