Clear-Com BS850 (Last time buy) - Manual (Page 41)

38
Upload Beltpac Settings:
You can upload Beltpac settings from the base to a Beltpac (connected to the configuration port of
the base) using the Configure tab>Upload Beltpac box> Beltpac>Upload path> Upload button.
Before pressing the Upload button, be sure the correct Beltpac has been selected from the Select
Beltpac Settings box.
NOTE: A Beltpac must be connected to the BELTPAC CONFIG connector on the base front panel to
enable uploading of Beltpac settings. To ensure new settings are properly activated, turn the Beltpac
off and disconnect it after uploading. Beltpacs will not accept settings changes while a talk button is
held or latched.
Copy Beltpac Settings:
As shown above from the Configure tab>Upload Beltpac box> Beltpac>Upload path> Copy
button, you can copy settings from one Beltpac to all others (for all settings except ID numbers,
names and transmit frequencies).
NOTE: This copy does not change ID numbers, names and transmit frequencies. All other settings
will be copied from the selected Beltpac to all other Beltpacs (BP1 – BP16).