beautypg.com

Beltpac user identifier settings – Clear-Com BS850 (Last time buy) User Manual

Page 40

background image

37

Beltpac User Identifier Settings:

You can change the Beltpac Identifier from the Configure tab>Edit Beltpac Identification box>
Beltpac>Identify

path as shown below:


To assign identification to a Beltpac, such as a user’s name, select a Beltpac and assign a name and
ID number to each Beltpac.

NOTE:

Each Beltpac must have a different ID number, and each assigned number must be

programmed into the base, or the base will not recognize the Beltpac. Beltpacs with firmware version
A.2.01 and newer can use any ID in the range 1 – 65000. Older Beltpacs with firmware version A1.xx
can only use certain ID’s. See Beltpac ID Restrictions application note for details. Beltpac names are
optional and are used by the system when displaying Beltpac status. Name changes do not have to
be uploaded to Beltpacs to be displayed on the base or PC850. They only need to be uploaded if
PDA850 is used to access Beltpacs remotely.


This manual is related to the following products: