Clear-Com BS850 (Last time buy) - Manual (Page 32)

29
PC850 Beltpac Configuration Settings:
The PC850 Configuration Tab allows you to view and edit Beltpac settings as well as perform
Beltpac-related functions including:
• Transmitters – Power and Frequency
• Receivers – Frequency and Squelch Control
• Buttons/LED – Buttons A, B, C and D and LED functions
• Tones – Tones for Alert, Confirmation, Error, etc.
• Identification – Beltpac Name and ID
• Upload – Upload Beltpac settings using the Beltpac configuration port on the base
• Copy – Copy Beltpac settings from one Beltpac to all others
NOTE: In all of the Beltpac menus described below, the Cnfg Beltpac refers to a Beltpac that is
connected to the Configuration Port on the front panel of the base. If the PC850 is connected to the
base, online, changes to parameters associated with Cnfg will take effect on the connected Beltpac
immediately.
Beltpac configuration settings are stored in the base, but do not become effective until they are
uploaded into individual Beltpacs. In a Master/Slave configuration, all Beltpac setting changes must
be made at the Master. Uploading is also done at the Master. Be sure to SYNC bases after making
setting changes at the Master.
NOTE: Settings for Beltpacs BP1-BP16 are stored in the base. Changes to Beltpac settings will not
be effective until they are uploaded to the Beltpacs. BP Cnfg is the Beltpac that is plugged into the
base, therefore changes to its settings are effective immediately and are not saved in the base.
SECTION 6. PC850 BELTPAC CONFIGURATION