Clear-Com i-Series Panels - Manual (Page 51)

7.3.1 Expansion Out Connector
The connector labeled J1 is an RJ-45F that connects the i-Series panel to an expansion
panel. Shielded category-5 cable is required.
7.3.2 DB-15M Connector (Reserved for Future Use)
The connector labeled J2 is a DB-15M connector reserved for future use.
7.3.3 To Matrix Connector
The connector labeled J3 is an RJ-45F that connects the i-Series panel to an Eclipse
matrix. Shielded category-5 cable is required.
7.4 AUX-101 Auxiliary Options Module
The auxiliary options module connects your i-Series panel to the following audio and
control inputs and outputs:
• General purpose inputs
• Relay outputs
• Speaker-feed output
• Line-level output
• Hot-microphone output
• Program input
• Auxiliary microphone input
Figure 7-3 Auxiliary Options Module Connectors shows the location of each connector on
the auxiliary options module.
Figure 7-3 Auxiliary Options Module Connectors
7.4.1 General Purpose Inputs Connector
The DB-15F connector labeled “J5A” connects your i-Series panel to two local general
purpose inputs (GPIs). The remaining six local general purpose inputs are reserved for
future use.
The general purpose inputs connector is provided so that you can connect an external
logic device—such as an external foot switch, a panel-mounted switch, or the logic output
of some other device—to your panel.
J5A/GPI
PROG
J 6
SPKR OUT
J 7
LINE
HMO
J 8 J 9
MIC
J 10
General Purpose Inputs DB-15 connector
Relay Outputs DB-15 connector
External Speaker Input
Line-Level Output
Hot-Microphone Out
A3M-type connector
Program Input
A3F-type connector
External Dynamic Microphone
A3F-type connector
J5A
J5B
J6
J7
J8
J9
J10
J5B/RELAY
Tip/Ring 1/8-inch mini-connector
Tip/Ring/Sleeve 1/8-inch mini-connector
51 I-Series Panels User Guide