Clear-Com i-Series Panels - Manual (Page 26)

4.6.2 Adjusting the program input volume
Important note:
You receive program input at your panel through the AUX-101 auxiliary options module.
The AUX-101 module must be installed to the panel before you can adjust the program
input.
You adjust the program input volume on your panel’s speaker and headset using the
program input volume control (VOL/PROG) on the function key module.
Turn the knob clockwise to increase the volume, counterclockwise to decrease it.
4.6.2.1 Program input volume lights
The six LEDs located to the left of the program volume knob indicate the program volume
level. As the volume goes up or down, the number of LEDs that are lit changes.
Minimum volume is indicated by one illuminated LED. The maximum volume is indicated
by six illuminated LEDs.
You control the brightness of the six-segment LED with the Display Brightness settings in
ECS / EHX. For more information, see the ECS / EHX User Guide.
Tip: You can also use the program volume knob to adjust listen levels, to scroll through
menu items, and to select menu items. These functions are discussed later in this chapter.
4.6.3 Adjusting listen levels
When you are required to monitor several incoming sources at once, you can vary the
volume of the sources by setting the listen levels.
For example, in a control room you may be listening simultaneously to the lighting
department, the sound department, and the tape editing department, but because you
need to cue the director when the show is ready to go on the air, listening to the tape
editing department takes highest priority. You need to adjust the volumes (the listen levels)
of the monitored sources so that the tape editing department is louder than the others.
4.6.3.1 Method 1
To adjust the listen level of an incoming source:
1. Press the desired listen key. The listen key is lit bright green .
2. Press and release the VOL/PROG control. The listen key flashes dim green .
3. Press and release the listen key again. The listen key is lit bright green .
4. To increase the source’s volume (listen level), turn the VOL/PROG control
clockwise.
To decrease the source’s volume (listen level), turn the VOL/PROG control
counterclockwise.
26 I-Series Panels User Guide