Clear-Com i-Series Panels - Manual (Page 39)

Note:
Local Page Override is only available when the Eclipse / Eclipse HX matrix is connected
and online.
To activate Local Page Override:
1. To enter Local Page Override mode, press 3 on the keypad.
2. Press any talk key (even an already latched key).
You can now talk to all destinations associated with that key. The current on/off
settings and volume levels are overridden at those panels’ speakers.
Note:
The Local Page Override feature does not work with the answer-back (ANSWR)
key. The 3 key on the keypad is lit
bright green while this feature is active.
If a key cannot be page overridden because it is assigned as an interface or
partyline, there will not be an error message to indicate that the function is not
available on that key.
3. To exit Local Page Override, release the pressed talk key.
Tip: Local Page Override mode automatically times out if you do not press a key
on the function-key module for five seconds.
6.5 IFB, partyline and Fixed Group assignments (#4 key)
Pressing the 4 key enables local assignments to be made for IFBs, partylines and Fixed
Groups.
To access assignment mode:
1. Press the 4 key. The CLEAR key is lit bright red and IFB is displayed below it.
2. To access partyline mode press the CLEAR key. PL is displayed below the key.
3. To access Fixed Group mode press the CLEAR key again. FG is now displayed
below the key.
4. To exist assignment mode, press the CLEAR key again.
6.5.1 Setting up IFB sources and destinations
Note:
Only Global IFBs with talk are valid as IFB destinations and only sources with listen are
valid for assignment to an IFB.
To set up IFB sources and destinations on an I-Series panel
1. Press the 4 key. The CLEAR key is lit bright red and IFB is displayed below it.
All valid IFB destinations flash red .
2. Press the front-panel button for the required IFB destination. The destination is lit
bright red , while all valid sources blink green .
3. Press a source’s button to assign it to the destination. The source is lit bright
green . Pressing the button again deactivates the assignment.
4. Repeat steps 3 and 4 until all sources are assigned to the IFB destination.
5. To exit IFB mode, press the CLEAR key three times.
39 I-Series Panels User Guide