Clear-Com i-Series Panels - Manual (Page 43)

codes before entering Local Key Assignment mode. The display will ask for the PIN code
at which time you must enter the correct 4-digit code.
6.6.4 Clearing a listen assignment
To clear a key’s listen assignment on your panel:
1. Press the 5 key on the numeric keypad. A list of current panels and interfaces in
the system that may be assigned as either talk keys or as talk-with-listen keys is
displayed on the function key module screen.
2. Press the LISTEN key to display all listens (sources) in the system.
3. The first item on the talk list is clear. Select clear by pressing in and releasing the
VOL/PROG knob.
The display reverts to showing currently assigned sources and destinations.
4. Press (tap) the key with the listen assignment that you want to clear.
You will hear a confirmation tone of two loud beeps to indicate that the key’s
assignment is cleared. The key’s label disappears from the display and the key
itself will not illuminate.
6.7 Swap Page (#6 Key)
The 6 key toggles between the main page and the swap page.
Pressing the 6 key with the main page displayed (normally the default panel state) causes
the main panel assignments to be replaced by the swap page assignments.
Pressing the 6 key again reverts to the main page display.
6.8 Local Preferences (#7 Key)
The Local Preferences feature enables you to adjust your panel’s volume settings. Local
Preferences enables you to:
• Reset listen levels to the default.
• Adjust the gooseneck microphone volume level.
• Adjust the headset microphone volume level.
• Adjust the sidetone volume level.
Note:
Local Preferences is only available when the Eclipse / Eclipse HX matrix is connected
and online.
43 I-Series Panels User Guide