Clear-Com i-Series Panels - Manual (Page 17)

4 Using I-Series panels
This chapter describes how to use the I-Series panels, including:
• Powering up I-Series panels.
• Front panel lights and controls.
• Key module lights.
• Answer-back (reply key) functionality.
• Volume controls.
• Upgrading I-Series panels.
Tip: For a brief description of all the 1-Series panels covered by this guide, including
product numbers, see Table 1: I-Series user panels covered by this guide.
4.1 Powering up I-Series panels
4.1.1 Powering up panels with non-display key modules
When a panel with non-display key modules is connected to power, the keys on each key
module flash
red , then green .
The keys then revert to their programmed colors ( red for Talk or Talk-with-Listen, or
green for Listen).
Note:
If there is no communication with the Eclipse / Eclipse HX matrix, the keys will flash red
once per second until communication to the matrix is established.
4.1.2 Powering up panels with display key modules
When a panel with display key modules is connected to power, each of the display
modules will show the following message:
Clear-Com
Vx.x.x@2000
Where V.x.x.x represents the firmware version of the panel.
All keys will flash
red , then green , and then display their programmed colors and labels if
there is communication with the matrix.
17 I-Series Panels User Guide