Clear-Com i-Series Panels - Manual (Page 46)

In this example, the current sidetone level is 10 dB. To increase the sidetone, you press
the ANSWR key, and to decrease the sidetone, you press the CLEAR key. Each time you
press either the ANSWR or CLEAR key, you increase the sidetone level by one increment.
The selected volume level is highlighted in the display. You can also change the sidetone
level by rotating the VOL/PROG knob.
When you reach the desired volume level, either press the ENTER key (labeled “#GRN”),
or press the VOL/PROG knob in, as if it were a key, to save the information. Then exit
“local preferences” mode.
As you scroll through the volume-level scale, the sidetone volume level will change
accordingly. To make the change permanent however, you must select the desired value
on the scale by either pressing in the VOL/PROG knob or by pressing the ENTER key
(labeled “#GRN”) when the value appears in the display.
Note:
If you change this parameter locally, the EHX software can only change It by performing a
black reset. Otherwise, the EXH sotware can download changes without a black reset.
Exit
When you select the “exit” menu item, you exit “local preferences” mode. To select the
item, scroll to it, then press the VOL/PROG knob in or press the ENTER key (labeled
“#GRN”).
6.9 Accessing port information (#9 Key)
The port information feature gives you the following information about your panel:
• The panel’s port number at the central matrix
• The panel’s label at the central matrix
• The panel’s current firmware version number
Your panel must be connected to the central matrix to access all of the port information. If
your panel is not connected to the central matrix, only the panel’s current firmware version
number will be displayed.
To obtain port information:
1. Press the “9” key on the numeric keypad to enter “port information” mode.
The leftmost display on the panel will show the panel’s current matrix port number,
matrix label, and firmware version number.
2. Press the ESCAPE key (labeled “*RED”) to exit.
The display will automatically time out after five seconds.
You can also access this feature through the menu. For more information, see “Accessing
Feature Menus” later in this chapter.
6.10 Clearing the Current Programming:
1. Press the CLEAR key (labeled “0 CLR”) on the numeric keypad to clear the current
entry on the leftmost display and take you back to the previous menu, if any.
6.11 Escaping the Current Programming
1. Press the ESCAPE key (labeled “*RED”) on the numeric keypad to abandon all
unsaved programming and revert the panel to normal use.
46 I-Series Panels User Guide