2 clearing a talk assignment, 3 assigning a remote source to a listen key, Clearing a talk assignment – Clear-Com i-Series Panels User Manual

Page 42: Assigning a remote source to a listen key

6.6.2

Clearing a talk assignment

To clear a key’s talk assignment on your panel:

1. Press the 5 key on the numeric keypad. A list of current panels and interfaces in

the system that may be assigned as either talk keys or as talk-with-listen keys is
displayed on the function key module screen.

2. The first item on the talk list is clear. Select clear by pressing in and releasing the

VOL/PROG knob.

The display reverts to showing currently assigned sources and destinations.

3. Press (tap) the key with the talk assignment that you want to clear.

You will hear a confirmation tone of two loud beeps to indicate that the key’s
assignment is cleared. The key’s label disappears from the display and the key
itself will not illuminate.

6.6.3

Assigning a Remote Source to a Listen Key

To assign a remote source to a key on your panel as a listen:

1. Press the 5 key on the numeric keypad. A list of current panels and interfaces in

the system that may be assigned as either talk keys or as talk-with-listen keys is
displayed on the function key module screen.

2. Press the LISTEN key to display a list of current panels and interfaces that are

available to assign as listen keys.

3. Scroll through the list of current available listen keys by either:

• Turning the PROG/VOL control.
• Pressing the CLEAR key to scroll up the list and the ANSWR key to scroll

down the list.

Tip:

The lists are sorted alphanumerically (symbols first, then numbers, then

letters. You can jump to the desired alphabetical area of the list by pressing the
corresponding letter key on the keypad. Press the A key to jump to the first label
that begins with an A, press the B key to jump to the first label that begins with a
“B,” and so on.

4. Select the desired panel or interface when it is highlighted in the display by

pressing in and releasing the VOL/PROG knob.

The key is lit

bright green

to indicate it is a listen key. The new label for that key

appears in the display.

5. To exit assignment mode, press the Escape key (*RED).

Tip:

To exit the current menu only, and return to the previous menu, press the

FUNCTION-CLEAR key (0 CLR).

Note:

If PIN codes are set up in ECS / EHX, you must enter one of the four possible 4-digit PIN

I-Series Panels User Guide