Clear-Com i-Series Panels - Manual (Page 34)

Tip: To use call tones, call tones must be enabled for the destination user panel or
interface in ECS / EHX. For more information, see the ECS / EHX User Guide.
To send a call signal:
1. Press and hold the LISTEN key for between 1 and 5 seconds. To indicate that you
have entered call-signal send mode, the LISTEN key is lit bright red .
2. Press the key of the destination that you want to send the call signal to.
A call signal of three loud beeps is sent to the destination every time that you
press the destination’s key.
3. Repeat step 2 for any other destination you want to send a call signal to.
4. To exit call-signal send mode, press (tap) the LISTEN key and release.
Tip: You can also exit call-signal send mode by simply not pressing a display key
for five seconds. The mode will automatically time-out.
5. On exiting call-signal send mode, the LISTEN key changes from bright red to no
illumination.
Sending a call signal to multiple destinations
You can send a call signal to any destination with a designated key on your panel. If more
than one destination is assigned to a key, each destination will receive the call signal. If
the destination is a partyline, then every panel listening on the partyline will receive the call
signal.
Note:
The call signal is sent at the page-override volume level, which you set in ECS / EHX. For
more information, see the ECS / EHX User Guide.
5.5.3 Releasing remote telephone lines
To release a telephone interface that has been left off-hook with the LISTEN key:
1. Enable remote telephone release for the panel in ECS/EHX.
Tip: Often this feature will already be set up in ECS/EHX. For more information,
see the ECS/EHX User Guide.
2. Press and hold the LISTEN key for more than 5 seconds. The LISTEN key turns
bright green and flashes on and off.
3. While still holding the LISTEN key, press the desired telephone interface key on
any key module.
The telephone interface will hang up. All audio paths to and from the telephone
interface will be deactivated.
4. Release the LISTEN key to exit.
34 I-Series Panels User Guide