Burkert Type 8076 - Manual (Page 64)

62
Adjustmentandcommissioning
9.15.3. checking the outputs behaviour
See chap. 9.10 to access the Test menu.
The feature allows for simulating the measurement of the physical parameter or the value of the totalizer to check
if the outputs are correctly configured.
The T icon is displayed in place of the icon as soon as the check for the correct working of an output
has started. During the check the related output does not react according to the measured physical value.
PVar:
Value: INPUT
Flow_L
Flow_m3
Flow_gal
Flow_Igal
Freq.
Tot1_L
Tot1_m3
Tot1_gal
Tot1_Igal
Tot2_L
Tot2_m3
Tot2_gal
Tot2_Igal
Test Sensor
PVAR: choose the physical parameter or the totalizer to be tested.
VALUE: enter a physical parameter value by modifying the flow time unit or a totalizer value, depending on the
choice made in the “PVAR” function above, to check output behaviour.
9.16. information menu
See chap. 9.10 to access the Info menu.
Error Info
Warning
Smiley
Software Main
Sensor
Soft.Main
E:MESSAGE
W:MESSAGE
MESSAGE
Not set
This menu makes it possible to read:
• a short description of the cause that generated an event related to the following icons, when they are displayed
by the device:
- ERROR: ERR
- WARNING:
- SMILEY: or
See also "If you encounter problems" at chap. 10.3
• the software version (function “SOFTWARE”) of the acquisition/conversion board for the physical parameters
measured.
English
Type 8026- 8036- 8076