Burkert Type 8076 - Manual (Page 55)

53
Adjustmentandcommissioning
See also "If you encounter problems" in chap. 10.3
9.12.10. setting the parameters of the transistor outputs
See chap. 9.10 to access the Param menu. The 2nd transistor output "TR2" is only available on a version with 2
transistor outputs.
Param TR1 / TR2 PVar:
Mode: Hysteresis
Low: INPUT
Contact: Normally open
Normally closed
Window
High: INPUT
Delay: INPUT
Outputs
Pulse
Flow_L
Flow_m3
Flow_gal
Flow_Igal
Freq.
Tot1_L
Tot1_m3
Tot1_gal
Tot1_Igal
Tot2_L
Tot2_m3
Tot2_gal
Tot2_Igal
Warning
If "Mode" ≠ "Pulse"
Pulse: INPUT
If "PVar" ≠ "Warning"
If "Mode" ≠ "Pulse"
If "Mode" = "Pulse"
This is
when the
device is be-
ing parame-
tered............
.................... This is
when the
device is be-
ing parame-
tered............
....................
PVAR: Choose a physical parameter (flow rate volume unit or input frequency) or a totalizer associated with tran-
sistor output 1 or transistor output 2 respectively or associate the “warning” event (see chap. 9.14.2) with tran-
sistor output 1 or transistor output 2 respectively. If the selected transistor output is linked to the "warning" event,
the transistor switches as soon as such an event is generated by the device.
MODE: Choose either the hysteresis or window operating mode, for transistor output 1 or transistor output 2, or
operating on pulse mode (choice “Pulse”) for transistor output 1 or transistor output 2.
LOW: enter the low switching threshold value for transistor output 1 or transistor output 2, as well as the flow rate
time unit. See details on next page.
HIGH: enter the high switching threshold value for transistor output 1 or transistor output 2, as well as the flow
rate time unit. See details on next page.
CONTACT: choose the type of off-position (normally open, NO, or normally closed, NC) for transistor output 1 or
transistor output 2. See details on next page.
DELAY: choose the value of the time delay prior to switching (from 0 to 60 s) for each transistor output.The time
delay before switching is applicable to both switching thresholds.
English
Type 8026- 8036- 8076