Burkert Type 8076 - Manual (Page 37)

35
Adjustmentandcommissioning
9. ADjusTmenT AnD commissioninG
9.1. safety instructions
Warning
risk of injury due to non-conforming adjustment.
Non-conforming operating could lead to injuries and damage the device and its surroundings.
• The operators in charge of adjustment must have read and understood the contents of this manual.
• In particular, observe the safety recommendations and intended use.
• The device/installation must only be adjusted by suitably trained staff.
Warning
Danger due to nonconforming commissioning.
Nonconforming commissioning could lead to injuries and damage the device and its surroundings.
• Before commissioning, make sure that the staff in charge have read and fully understood the contents of the
manual.
• In particular, observe the safety recommendations and intended use.
• The device / the installation must only be commissioned by suitably trained staff.
protect this device against electromagnetic interference, ultraviolet rays and, when installed
outdoors, the effects of the climatic conditions.
9.2. When switching on the device
When the device is switched on or the display module mounted on the electronic module, the display indicates
the software version of the display. The display then shows the first screen of the Process level:
OP
EN
LO
CK
flow_l
1243 l/h
See chap. 9.12.4 to 9.12.7 to choose the data to be displayed in
the Process level.
If the message “ERROR - This display does not support this
Element - Contact Bürkert” is displayed, the version of the display
module is not compatible with the software version of the device.
Contact your Bürkert reseller.
Figure 36 : Display indications when powering on the device
English
Type 8026- 8036- 8076