Burkert Type 8076 - Manual (Page 53)

51
Adjustmentandcommissioning
9.12.7. setting the parameters for the reading comfort level of the
data displayed
See chap. 9.10 to access the Param menu.
Contrast xx%
Backlight xx%
Display Param
This is
when the
device is be-
ing parame-
tered............
.................... This is
when the
device is be-
ing parame-
tered............
....................
Set each percentage using and .
CONTRAST: Choose the display contrast level (as a %).
BACKLIGHT: Choose the light intensity of the display (as a %) on a version with 2 fixed connectors only.
These settings only affect the display module. They are not factored in during a device data UPLOAD (see
chap. 9.12.1).
9.12.8. Defining the connection mode of the outputs
See chap. 9.10 to access the Param menu.
HWMode Param Outputs sinkNPN
sourcePNP This is
when the
device is be-
ing parame-
tered............
.................... This is
when the
device is be-
ing parame-
tered............
....................
On a version of the device with an NPN transistor output and a current output, only the choice “sink/NPN” is
possible.
The setting has no effect on a version with one fixed connector, 2 transistor outputs and a single current
output, if the sole current output is wired. See Figure 21.
The wiring mode is the same for all outputs.
If you choose "sink NPN", the current outputs must be wired in sinking mode and the transistor outputs in NPN
mode.
If you choose "source PNP", the current outputs must be wired in sourcing mode and the transistor outputs in
PNP mode.
See the wiring for the outputs in chap. 8.3.
9.12.9. setting the parameters of the current outputs
See chap. 9.10 to access the Param menu. The 2nd current output "AC2" is only available on a version with 2
current outputs.
English
Type 8026- 8036- 8076