Burkert Type 1150 - Manual (Page 90)

88 - 1150
O
PTIMIZATION
Starting self-optimization
Start at the operating level
Select the controller channel in / Operation level / Self-optimization / Controller number 1 to 4
Start self-optimization for the selected controller channel with / Status / „Active“
Start from the operating loop
Change the screen template for the required controller channel with (press repeatedly, if
necessary!)
Press
Press
Start self-optimization for the required controller channel with
Pressing resets the significance of the softkeys.
The controller outputs types have to be defined for self-optimization. They also have to be
enabled for the corresponding controller channel for self-optimization to start.
(see Chapter „
Controller“).
NOTE
Canceling self-optimization
Switch the “Status” parameter at the operating level to “inactive” or press again.