Burkert Type 1150 - Manual (Page 57)

1150 - 55
C
ONFIGURATION
(1) Move to measurement point
(2) Enter start value 1)
(3) Move to measurement point
(4) Enter end value E 1)
Programming
1) If start value=0 or end value=1 is to be set, then the value must first be altered using or
to enable correction.
If recalibration is carried out without a reference instrument, the offset must be taken into
account when moving to measurement point (3). NOTE
To cancel recalibration, the start and end values have to be programmed to the same value. This
automatically sets the start value to 0 and the end value to 1.
Any subsequent recalibration will otherwise be based on the corrected characteristic.