Burkert Type 8695 - Manual (Page 19)

19
Installation
3. install control head
noTe!
Damaged printed circuit board or malfunction.
▶ Ensure that the puck is situated flat on the guide rail.
→
Align the puck and the control head until
1. the puck can be inserted into the guide rail of the control head
and
2. the connection pieces of the control head can be inserted into the pilot air ports of the actuator.
Connection
pieces
Pilot air ports
(actuator)
Guide rail
Puck
Guide rail
Puck
Connection
pieces
Figure 7: Aligning the puck and the connection pieces
english
Type 8695