Datamax-O'Neil Performance series User Guide - Manual (Page 97)

Menu System | 4
119 Performance Series User’s Guide
Select Calibrate Display and then select either the green Accept button to continue or the
red Reject button. Upon selecting to continue, follow the on-screen directions to properly
calibrate the touchscreen display.
If the touchscreen display becomes unusable, the printer can be calibrated during power-
up as well. To calibrate during power-up, perform the following procedure beginning with
the printer powered off.
1. Press and hold the Reset button on the back of the printer.
2. Toggle the power switch to power-on the printer.
3. Continue to hold the Reset button for ten (10) seconds.
4. Follow the on-screen instructions to calibrate the display.
Note: Allow a few minutes for power-up to complete.
Security
The security settings may be adjusted. These adjustments include changing the
password as well as changing the security level.
To change the password, perform the following steps:
1. Select Change Password.
2. Enter the old password using the on-screen keyboard.
3. Select the green Accept button to accept the entry or the red Cancel button to reject
the entry.
4. Enter the new password and select either the green Accept button or the red
Cancel button.
5. Re-enter the new password and select either the green Accept button or the red
cancel button.
To change the security level, choose from the following options:
Table 19: Security Settings
Security Descriptions
Functions Options
Security Level Off
Secure
Secure All
3 Button Display