Datamax-O'Neil Performance series User Guide - Manual (Page 80)

4 | Menu System
Performance Series User’s Guide 102
Table 1: Paper Sensor Options
Ribbon Mode
The Ribbon Mode option allows the user to enable and disable Ribbon Mode and notes
the type of ribbon being used.
Ribbon Mode has three settings:
• Coated In (CSI) - for thermal transfer printing
• Coated Out (CSO) - for thermal transfer printing
• None - for direct thermal printing
Print Adjust
The Print Adjust selection allows for the adjustments of both the darkness and the
contrast of print quality as well as horizontal and vertical adjustments.
Selecting the plus or minus buttons respectively increases or decreases the values.
Changes to the values may also be made by selecting the field and entering the
appropriate values using the numeric keypad. During printing the print adjust screen will
be available via an icon in the mode indicator area of the front display. When paused the
icon will be accessible via the home screen icon.
Note: Settings that use the word “Adjust” should be considered fine adjustments and are
not main settings.
a. Darkness
The darkness adjustment is set within the range of -20 to +20. To increase darkness,
adjust the settings in a positive (+) direction.
1. Enter the appropriate value in the field.
Paper Sensor Type Paper Sensor Side
Gap Inside
Outside
Mark on Top Inside
Outside
Mark on Bottom Inside
Outside
Notch Inside
Outside
Continuous Inside
Outside