Datamax-O'Neil Performance series User Guide - Manual (Page 135)

Terms and Definitions | 8
163 Performance Series User’s Guide
Advanced > Communications > Serial
Advanced > Communications > General
Advanced > Communications > General > Services
Advanced > Communications > General > Host Timeout
Advanced > Adjustments
Gateway The user-entered value that specifies the network gateway
address with which the interface should connect.
Terms Definitions
Baud Rate Sets the serial communications rate in bits per second.
Data Bits Sets the word length.
Stop Bits Sets the number of stop bits.
Parity Sets the word parity.
Protocol Serial communications handshaking mechanism.
Term Definition
Enable NTP (Network Time
Protocol) Enables the Network Time Protocol for synchronizing the clock.
Enable SSH Enables the Secure Shell network protocol.
Enable Webpages Enables the Webpages utility. If enabled, Webpages are served
by the printer to provide printer status and other information,
and also allow the user to configure the printer.
Enable SNMP Enables Simple Network Management Protocol.
SNMP Trap Sets the IP address to send SNMP alerts.
Enable LPD Enables LPD network protocol on port 515; using queue name
“lp”
Terms Definitions
Host Timeout Print job input timeout in seconds before moving on to monitor
other ports.
Terms Definitions
Present Distance Adjust User-entered value allowing for the adjustment of the tear bar
position due to mechanical variations.
Cut Distance Adjust User-entered value allowing for the adjustment of the cut
position due to mechanical variations.
Terms Definitions