Analog Way Smart Quad - Manual (Page 64)

If you need to use your own Software Control program from a
PC or automation, the device allows communication through an
ASCII code protocol. All commands can be found on our website:
www.analogway.com
All Analog Way products equipped with an RS232 input are
compatible with Crestron, AMX, Medialon, and most major control
systems. TCP/IP control ports are also available on most Analog
Way products, as standard or as options.
To control an SQD200 product with an External Remote Controller
(PC Software Control - Touch Pad Controller…) follow the indications
below:
1. First establish a connection between the Remote Control Software
and the
SQD200 . Select the RS232/LAN option from the “Control”
menu, and the equivalent in your RCS.
If using RS232 no further setup is required.
2. If using a LAN setup select the TCP / UDP option from the “LAN
setup” menu.
3. Configure the LAN address in your RCS eg 192.168.000.001.
4. Configure the TCP option from the “LAN setup” menu.
In example on the Remote Software in the “Control” - “RS232/LAN
Setup” - “LAN/Setup” menu.
5. Setup the LAN parameters in UDP mode in the “Console” - “LAN
Setup” menu.
Example:
Device address 192.168.0.2
Gateway 192.168.0.1
Device port 10500
Netmask 255.255.255.000
If using a UDP LAN connection you must set up the Remote address
and Remote Port as well.
Once the connection has been setup, you can use your RCS to
control your
SQD200 .
7-1. EXTERNAL PROGRAMMING
62
EXTERNAL PROGRAMMING