B&K Precision 5492BGPIB - Manual - Manual (Page 79)

SCPI Command Reference
79
6.3.4 SENSe subsystem command
This SENSe subsystem is used to configure and control the 5492B measurement functions and are
summarized in Table 6-4 below.
Table 6-4 SENSe Command Summary
Command Function Description Default
[:SENSe[1]]
:FUNCtion
:FUNCtion?
:DATA?
Select measurement function: ‘VOLTage:AC’,
‘VOLTage:DC’, ‘RESistance’, ‘FRESistance’,
‘CURRent:AC’, ‘CURRent:DC’, ‘FREQuency’,
‘PERiod’, ‘DIODe’, ‘CONTinuity’.
Query function.
Output the latest reading
VOLT:DC
:CURRent:AC
:NPLCycles
:NPLCycles?
:RANGe
[:UPPer]
[:UPPer]?
:AUTO
:AUTO?
:REFerence
:STATe
:STATe?
:ACQuire
:REFerence?
:AVERage
:TCONtrol
:TCONtrol?
:COUNt
:COUNt?
:STATe
:STATe?
Path to configure AC current
Set A/D integration rate (Line cycle; 0.1 to 10)
Query line cycle integration rate
Path to configure measurement ranges
Select range
Query range
Enable or disable auto range
Query auto range
Specify reference (-10 to 10)
Enable or disable reference
Query state of reference
Use input signal as reference
Query reference value
Path to configure and control the filter
Select filter type(MOVing or REPeat)
Query filter type
Specify filter count (1 to 100)
Query filter count
Enable or disable filter
Query state of digital filter
1
10
ON
0
OFF
5
OFF