B&K Precision 4045B - Manual - Manual (Page 86)

86
Rounding: to 4 digits
Command Type: Setting or Query
Setting
Syntax: RATE[units]
RATEMINimum|MAXimum
Examples: RATE 100NS
Query
Syntax : RATe?[MINimum|MAXimum]
Response: NR3
Note: You can alternately use the :ARB:PRATe
command.
AMPLitude
The amplitude command is used to set the peak-to-peak
amplitude of the output waveform. Note that the amplitude
and the offset are limited by the relation:
Peak Amplitude + |Offset| <= 5V
Arguments
Type: Numeric
Units: V, mV, VPP, mVPP
Range: 10mV to 10V
Rounding: 1mV for 10mV to 999mV. 10mV for 1V to
10V.
Command Type: Setting or Query
Setting
Syntax: AMPLitude[units]
AMPLitudeMINimum|MAXimum
Examples: AMPL 2.5