B&K Precision 4079 - Manual User Manual
50 mhz arbitrary function generator
This manual is related to the following products:
Table of contents
Document Outline
- Safety Summary
- Section 1
- Section 2
- Section 3
- Operating Instructions
- 3.1 General Description
- 3.2 Display Window
- 3.3 Front Panel Controls
- 3.4 Back Panel Controls
- 3.5 Output connectors
- 3.6 MENU Keys
- 3.7 ON Key
- 3.8 Cursor Movement Keys
- 3.9 Rotary Input Knob
- 3.10 Power-On Settings
- 3.11 Memory
- 3.12 Displaying Errors
- 3.13 Using The Model 4076 and 4079
- 3.14 Examples
- 3.14.1 Creating an Arbitrary Waveform
- 3.14.2 Entering Individual Data Points
- 3.14.3 Creating an Arbitrary Waveform
- 3.14.4 Setting the Arbitrary Frequency
- 3.14.5 Setting the Amplitude
- 3.14.6 Loading a Waveform into Execution Memory
- 3.14.7 Generating a Waveform Output
- 3.14.8 Using Voltage Offset
- 3.14.9 Storing and Recalling a Waveform Generator Setup
- Operating Instructions
- Section 4
- Programming
- 4.1 Overview
- 4.2 Device State
- 4.3 Interface Function Subsets
- 4.4 Device Address
- 4.5 Message Exchange Protocol
- 4.6 Block Data (GPIB Only)
- 4.7 Instrument Identification
- 4.8 Instrument Reset
- 4.9 Self Test
- 4.10 Command Syntax
- 4.11 Status Reporting
- 4.12 Common Commands
- 4.13 Instrument Control Commands
- 4.13.1 SOURce Subsystem
- 4.13.2 OUTPut Subsystem
- 4.13.3 Trigger Subsystem
- 4.13.4 Arbitrary Subsystem
- 4.13.4.1 Point Rate
- 4.13.4.2 Address
- 4.13.4.3 Data
- 4.13.4.4 Line Draw
- 4.13.4.5 Clear
- 4.13.4.6 Copy
- 4.13.4.7 Memory Protection Range
- 4.13.4.8 Memory Protection State
- 4.13.4.9 Predefined Waveforms
- 4.13.4.10 Start Address
- 4.13.4.11 Wavelength
- 4.13.4.12 Marker Address
- 4.13.4.13 Marker Length
- 4.13.4.14 Marker State
- 4.13.4.15 Save
- 4.13.5 Status Subsystem
- 4.13.6 System Subsystem
- 4.14 IEEE 488.1 Interface Messages
- 4.15 SCPI Command Tree
- 4.16 Block Transfer (GPIB only)
- 4.17 GPIB Communication Protocol
- Programming
- Section 5