B&K Precision 4045B - Manual - Manual (Page 53)

53
3.13.3 Using Voltage Offset
Through the offset parameter you can add a positive
or negative DC level to the output waveform.
To set voltage offset:
1. Select a waveform to display its menu.
2. Press F3:Offset to display the offset setting.
3. Use the rotary input knob or the numerical keys to
set the voltage offset.
To turn the voltage offset OFF, repeat the steps
above, but set the offset voltage level to 0.
3.13.4 Storing and Recalling a Waveform
Generator Setup
You can store front-panel setups inside the internal
non-volatile flash memory. When you recall a stored
setup, the front-panel settings change to match the
settings in the stored setup.
Storing Setups
To store the front-panel setup:
1. Press UTILITY to display the menu.
2. Press F2:Store to select the Store mode.
3. Use the rotary input knob to select a buffer
number. Valid buffer numbers range from 1 to 19
Buffer 0 is a read-only buffer that contains the
default setup/power-on settings from Table 1.