B&K Precision 4034 - Manual User Manual
50 mhz programmable pulse generator
This manual is related to the following products:
Table of contents
Document Outline
- Section 1
- Section 2
- Section 3
- Operating Instructions
- 3.1 General Description
- 3.2 Display Window
- 3.3 Front Panel Controls
- 3.4 Back Panel Controls
- 3.5 Output connectors
- 3.6 MENU Keys
- 3.7 ON Key
- 3.8 Cursor Movement Keys
- 3.9 Rotary Input Knob
- 3.10 Power-On Settings
- 3.11 Memory
- 3.12 Displaying Errors
- 3.13 Pulse Definitions
- 3.14 Pulse Parameter Limitations
- 3.15 Pulse Definitions
- Operating Instructions
- Section 4
- Programming
- 4.1 Overview
- 4.2 Device State
- 4.3 Interface Function Subsets
- 4.4 Device Address
- 4.5 Message Exchange Protocol
- 4.6 Instrument Identification
- 4.7 Instrument Reset
- 4.8 Self Test
- 4.9 Command Syntax
- 4.10 Status Reporting
- 4.11 IEEE 488.2 Common Commands and Queries
- 4.12 Instrument Control Commands
- 4.12.1 SOURce Subsystem
- 4.12.1.1 Frequency
- 4.12.1.2 High Voltage Level
- 4.12.1.3 Low Voltage Level
- 4.12.1.4 Predefined High Voltage Level
- 4.12.1.5 Predefined Low Voltage Level
- 4.12.1.6 Predefined Voltage Levels
- 4.12.1.7 High Voltage Limit
- 4.12.1.8 Low Voltage Limit
- 4.12.1.9 Pulse Period
- 4.12.1.10 Pulse Width
- 4.12.1.11 Pulse Delay
- 4.12.1.12 Pulse Duty Cycle
- 4.12.1.13 Pulse Hold
- 4.12.1.14 External Width
- 4.12.1.15 Double Pulse State
- 4.12.1.16 Double Pulse Delay
- 4.12.1.17 Leading Edge Time
- 4.12.1.18 Trailing Edge Time
- 4.12.1.19 Pulse Polarity
- 4.12.1.20 Channel Dependency
- 4.12.2 OUTPut Subsystem
- 4.12.3 Trigger Subsystem
- 4.12.4 Status Subsystem
- 4.12.5 System Subsystem
- 4.12.1 SOURce Subsystem
- 4.13 IEEE 488.1 Interface Messages
- 4.14 SCPI Command Tree
- 4.15 ASCII and GPIB Code Chart
- 4.16 RS-232 Programming
- Programming