B&K Precision 4045B - Manual - Manual (Page 50)

50
assumes power-on default settings. Table 1 lists the
factory default settings or selected after RECALL 0.
Table 1 – Power-on Default Settings
Key Function Value Description
Function Sine Output Waveform
Frequency 1.0000 kHz Waveform Frequency
Amplitude 5.00 V Peak-to-peak output
amplitude
Offset 0.00 V Zero DC offset
Output OFF Output disabled
Sweep OFF Sweep function disabled
Modulation OFF Modulation function
disabled
N-BURST 2 Wave per burst for burst
mode
Trig Source Continuous Continuous trigger
Trig Rate 10 ms Internal trigger rate
3.11 Memory
The waveform generator uses non-volatile flash
memory for storing the front panel settings.
Up to 20 front panel settings can be stored (includes
storage location 0 for factory default settings). One
1000 points Arbitrary waveform is stored in the flash
non-volatile memory.