Atec Rohde-Schwarz-CMW500 - Manual (Page 55)

Version 11.00, May 2013
Rohde & Schwarz R&S ® CMW500 Wideband Radio Communication Tester 55
Features
Connection status status indication signal on,
network entry completed,
waiting for CDMA RNG-RSP,
waiting for initial RNG-RSP,
waiting for SBC-RSP,
waiting for REG-RSP,
deregistered,
MS disconnected
MS capability tests sleep mode,
idle mode,
cell reselection,
handover
Cell reselection MS/BS scan initiation, neighbor cell
configuration for advertisement
Handover test MS/BS initiation, neighbor cell
configuration
Ranging control initial ranging, periodic ranging
Power control open loop, closed loop
Power boosting preamble, pilots, FCH, DL map, UL map,
data and management bursts
Burst allocation mode data burst region optimized,
normal
Bandwidth allocation mode data burst region dynamic,
fixed
Dummy burst generator unused symbols filled with pilots, dummy burst
Sample frequency offset −1000 Hz to +1000 Hz
AWGN CN ratio −6 dB to +40 dB, two channels
Trigger output WiMAX™ signaling: frame trigger
adjustable offset (positive and negative),
adjustable pulse width,
slope
Service flows fragmentation control,
UL ACK channel configuration
WiMAX™ IP application enabler (prerequisite: R&S
®
CMW-KA700,
R&S
®
CMW-B660, R&S
®
CMW-B661 options)
Key features throughput measurement and end-to-end
application testing
Interface rear panel 1 GBaseT
Convergence sublayer IP version V4
Protocols DHCP, RIP
DHCP support enable, disable (static IP)
Network settings WiMAX™ stack IP,
MS IP address (destination),
subnet mask,
gateway,
DNS server
Interface to IP-based server/client
applications e.g. IPERF (throughput test),
e.g. web browsing,
e.g. FTP file transfer,
e.g. video streaming,
e.g. VoIP
Data throughput end-to-end IP connection
DL: UDP, SISO up to 17.2 Mbps
DL: UDP, MIMO up to 36.5 Mbps
UL: UDP, SISO up to 9.7 Mbps