Atec Rohde-Schwarz-CMW500 - Manual (Page 34)

Version 11.00, May 2013
34 Rohde & Schwarz R&S ® CMW500 Wideband Radio Communication Tester
Frequency error
Measurement range ±80 kHz
Frequency measurement uncertainty < 20 Hz 18 + drift of timebase,
see general technical specifications
I/Q origin offset
Inherent I/Q offset < –50 dB
Inband emissions
Dynamic range allocated resource blocks ≤ 50,
f
RF
< 3300 MHz
> 50 dB
allocated resource blocks ≤ 50,
f
RF
> 3300 MHz
> 47 dB
Expected nominal power setting for full
dynamic range RF1 COM, RF2 COM see general technical specifications
Equalizer spectrum flatness allocated resource blocks ≤ 50
Level uncertainty < 0.5 dB
Spectrum measurements
Adjacent channel leakage ratio
Filter E-UTRA rectangle 1.08 MHz, 2.7 MHz, 4.5 MHz,
9 MHz, 13.5 MHz, 18 MHz
UTRA 1.28 MHz, RRC, α = 0.22, WCDMA filter
Dynamic range E-UTRA, f
RF
< 3300 MHz > 45 dB
E-UTRA, f
RF
> 3300 MHz > 42 dB
UTRA, f
RF
< 3300 MHz > 56 dB
UTRA, f
RF
> 3300 MHz > 53 dB
Expected nominal power setting for full
dynamic range RF1 COM, RF2 COM see general technical specifications
Spectrum emission mask (SEM)
Frequency span 70 MHz
Noise floor RBW → 1 MHz, f
RF
< 3300 MHz < –35 dBm
RBW → 1 MHz, f
RF
> 3300 MHz < –32 dBm
RBW → 100 kHz, f
RF
< 3300 MHz < –40 dBm
RBW → 100 kHz, f
RF
> 3300 MHz < –37 dBm
RBW → 30 kHz, f
RF
< 3300 MHz < –45 dBm
RBW → 30 kHz, f
RF
> 3300 MHz < –42 dBm
18 For frequency error measurements relative to the downlink signal of the same R&S ® CMW500, the uncertainty is in line with 3GPP TS 36.521-1 V9.3.0.