Franklin Fueling Systems TS 550 evo Fuel Management System Programming Guide - Manual (Page 18)

18
Units
Units Options
Volume
Liters
Gallons
Imperial Gallons
Length
Millimeters
Centimeters
Meters
Inches
Temperature
Centigrade
Fahrenheit
Flow
Liters/Hour
Cubic Centimeters/Second
Cubic Feet/Hour
Gallons/Minute
Gallons/Hour
FMS - Line Pressure
Pascal
Bar
Pounds per square inch
Inches of Water
Inches of Mercury
FMS Line Pressure
Pascal
Bar
Pounds per square inch
Inches of Water
Inches of Mercury
SCM - Containment
Vacuum
Pascal
Bar
Pounds per square inch
Inches of Water
Inches of Mercury
Density Units
Kilograms per Cubic Meter
Grams per cubic centimeter
Pounds per cubic foot
Mass Units
Kilograms
Grams
Pounds
System ID
The System ID screen looks like this:
You should have the following items ready before
beginning console programming:
• Site location information to setup Site ID
• Communications parameters for external equipment
to match console settings
• Wiring diagrams of site if necessary; to identify
sensor and/or probe location
• Manufacturers Tank Charts for “special” tank
correction tables
• Probe stickers with gradient and RTD location for
“special” probes
To make a modification, select the parameter that you want
to change. Type the new setting in using the characters
available. When finished, press enter to confirm the
change. Once changes are complete select the save
button. When Confirmation is displayed, press Yes to save
and apply, or No to exit without saving — you may press
cancel to continue making changes. Changes will not be
applied until you return to the main menu.
Refer to the programming tables on the following pages for
a more descriptive representation of each option including
the submenus of each menu item. The console will update
the menus as additional data or information is required
during programming.
Please note, features appearing in this guide may not
be available, unless the option is purchased with your
console.