YSI Vertical Profiler Systems - Manual (Page 107)

YSI Profiler System USER Manual
INHALATION: Not expected to be a problem. However, if respiratory
irritation, dizziness, nausea, or unconsciousness occurs due to
excessive vapor or mist exposure, seek immediate medical
assistance. If breathing has stopped, assist ventilation with a
mechanical device or mouth-to-mouth resuscitation.
INGESTION: Not expected to be a problem. Seek medical attention if
discomfort occurs. Do not induce vomiting.
------------------------------------------------------------------------
5. FIRE-FIGHTING MEASURES
------------------------------------------------------------------------
EXTINGUISHING MEDIA: Carbon dioxide, foam, dry chemical and water fog.
SPECIAL FIRE FIGHTING PROCEDURES: Water or foam may cause frothing.
Use water to keep fire exposed containers cool. Water spray may
be used to flush spills away from exposure. Prevent runoff from
fire control or dilution from entering streams, sewers, or
drinking water supply.
SPECIAL PROTECTIVE EQUIPMENT: For fires in enclosed areas, fire
fighters must use self-contained breathing apparatus.
UNUSUAL FIRE AND EXPLOSION HAZARDS: None.
COMBUSTION PRODUCTS: Fumes, smoke, carbon monoxide, sulfur oxides,
aldehydes and other decomposition products, in the case of
incomplete combustion.
Flash Point C(F): > 210(410) (ASTM D-93).
Flammable Limits (approx.% vol.in air) - LEL: 0.9%, UEL: 7.0%
NFPA HAZARD ID: Health: 0, Flammability: 1, Reactivity: 0
------------------------------------------------------------------------
6. ACCIDENTAL RELEASE MEASURES
------------------------------------------------------------------------
NOTIFICATION PROCEDURES: Report spills/releases as required to
appropriate authorities. U.S. Coast Guard and EPA regulations
require immediate reporting of spills/releases that could reach
any waterway including intermittent dry creeks. Report
spill/release to Coast Guard National Response Center toll free
number (800)424-8802. In case of accident or road spill notify
CHEMTREC (800) 424-9300.
PROCEDURES IF MATERIAL IS RELEASED OR SPILLED:
LAND SPILL: Shut off source taking normal safety precautions. Take
measures to minimize the effects on ground water. Recover by
pumping or contain spilled material with sand or other suitable
absorbent and remove mechanically into containers. If necessary,
dispose of adsorbed residues as directed in Section 13.
WATER SPILL: Confine the spill immediately with booms. Warn other
ships in the vicinity. Notify port and other relevant authorities.
Remove from the surface by skimming or with suitable absorbents. If
permitted by regulatory authorities the use of suitable dispersants
should be considered where recommended in local oil spill
procedures.
ENVIRONMENTAL PRECAUTIONS: Prevent material from entering sewers,
water sources or low lying areas; advise the relevant authorities
if it has, or if it contaminates soil/vegetation.
PERSONAL PRECAUTIONS: See Section 8
------------------------------------------------------------------------
7. HANDLING AND STORAGE
------------------------------------------------------------------------
HANDLING: No special precautions are necessary beyond normal good
hygiene practices. See Section 8 for additional personal
YSI Environmental 669523 Rev B Page F-2
protection advice when handling this product.