Xylem H-2192 - Manual (Page 50)

Signal Strength: XX
This is a status screen that shows the cell phone radio signal strength. The range is xx t xx. Levels
at xx and above indicate acceptable levels while levels below xx are questionable and calls may be
dropped.
Last Time Update:
This is just a status message that shows the last time data was sent to the unit. This time may be
local time or universal standard time or some other format based on what is sending the time
information to the unit.
N - Modem Turn On Time: 06:00:00
This option is used to enter the turn on time if the power mode is set to ‘Auto”, See the power mode
discussion above.
O - Modem Turn Off Time: 18:00:00
This option is used to enter the turn off time if the power mode is set to ‘Auto”, See the power mode
discussion above.
V - Modem Turn Off Voltage:
This option is used to set the low voltage level. If the voltage falls below this value the modem
power will turn off. To turn back on the voltage must raise up 0.5 volts above this value.
A - Cell Carrier APN:
This is a GSM only option and sets the APN used with GSM provider.
U - Cell Carrier Username:
This is a GSM only option and sets the username if required for the GSM provider.
V - Cell Carrier Password:
This is a GSM only option and sets the password if required for the GSM provider.
Current IP Address:
This field shows the current IP address assigned to the modem. If the address listed is 0.0.0.0 then
the cell modem isn’t powered or the cell provider hasn’t assigned it an IP address.
I - TCP Listen Port Number:
This option sets specifies the TCP port number which the modem is going to listen for incoming
connections. Note: If you specify port 0 it will disable incoming data connections.
5-10 Menu Mode Reference
H-219X