Xylem H-2192 - Manual (Page 37)

4.5 Alarm Call Out Commands
Command: ALARMSENABLED
Description: This command is a global enable of all alarms. All alarms will be inactive unless the
global alarm enable is activated using this command or done through the menu.
Command: ALARMSDISABLED
Description: This command is used to disable all alarms. All alarms will be ignored until
reactivated using the ‘alarmsenabled’ command.
Command: PHONE1 - PHONE8
Description: These commands are used to enter in the phone numbers that will be used to call out
when an alarm is activated.
Command: ALARM0 - ALARM9
Description: These commands are used to set an alarm so the unit will make outgoing calls. The
data logger will evaluate some condition to see if a call should be made. If the logger
determines an alarm condition exists, then it will set the desired alarm using this
command. The alarm is activated by setting it to a 1 and clearing the alarm by setting
it to 0.
Example: AVALARM9=1 Triggers alarm 10 and out going calls will be made.
The modem will also clear the alarm to 0 after acknowledgment. A suspended alarm will
be greater than 1.
H-219X
Modem Command Reference 4-7