Xylem H-2192 - Manual (Page 40)

Command: RADIOTURNOFFTIME
Description: This command is used to set the radio turn off time. The default is 18:00:00 so the
radio would turn off at 6 PM if the radio power mode is set to “Auto”.
Example: AVRADIOTURNOFFTIME=16:00:00
If the command is issued without the time option, then the current radio turn off time is
returned.
Command: RADIOLOWBATT
Description: This command is used to set the minimum measured battery voltage level to prevent
the radio from automatically turning off. If the radio is turned off because the voltage
dropped below this limit, then it will not turn back on until it is above this limit plus
0.5 volts. This helps to keep from having the radio power cycling fast due to the
voltage just sitting on the limit.
Command: RADIOIDCODE
Description: The radio will only answer if the incoming request matches the ID for this site. This
command is used to change or view the current ID for this site. The radio ID code
must be a 1 to 4 digit number in the range of 0 to 9999.
Command: SPEAKRADIO
Description: This command is used to send a voice message out the radio. This allows a data
logger to generate messages on its own.
Example: avspeakradio=this is a test.
Command: TESTRADIO
Description: This command is used to send the ID message out the radio port. The message will
be sent repeatedly with about a 1 second delay. This command will automatically
time out after sending the message 20 times or will end when the user presses any
key. This command is used mainly for diagnostics.
4-10 Modem Command Reference
H-219X