Xylem H-2192 - Manual (Page 36)

4.4 General Voice Commands
Command: IDMESSAGE
Description: This command is used to enter the site id message that will be spoken when the unit
is called or when it calls out in a voice mode. The message can be up to 128
characters but keep in mind the longer the message, then the longer it will take to
make the call.
Example: avidmessage=This is the logan river near first dam
OK
The command can also be used to see the current message.
Example: avidmessage
ID Message = This is the logan river near first dam
Command:
DATAMESSAGE01 to DATAMESSAGE10
Description: This command is used to enter the message that will be spoken to identify the data
for boxXX when the unit is called or when it calls out in a voice mode.
Command: ALARMMESSAGE0 to ALARMMESSAGE9
Description: This command is used to enter the message that will be spoken to identify an alarm
condition. This is only used when the unit calls out in a voice mode after an alarm
is detected.
Command: ALARMMESSAGET
Description: This command is used to enter the message that will be spoken to identify an alarm
caused by the external input.
4-6 Modem Command Reference
H-219X