Xylem H-2192 - Manual (Page 15)

2.5 Installing the H-219X
This chapter will help you to install and connect your H-219X. For proper installation, you will
need:
! The H-219X with mounting hardware
! The H-219X Owner’s Manual
! Communication cables
! For the H-2191, phone line cable with RJ-11 jack connectors for the land line connection
! For the H-2192, Antenna for cell phone. Make sure phone is activated before field trip!
! Cables for radio connection including any accessories needed by the radio
! Screw driver to make the power connections
! 18 gauge or larger wire for power and ground connections
! Power source (Battery, Solar panels, AC adaptor, etc.)
! Grounding rod and heavy copper wire for connecting the system to the grounding rod
The following paragraphs give a basic outline of the installation process. Your installation may
vary according to your intended application and site conditions.
! Choose the best place to mount the equipment. Wiring should be kept as short as
possible. Equipment with displays and keyboards should be easily accessible. Equipment
with exposed wiring terminals should be mounted with the terminals toward the bottom
of the case. Antenna cables should be kept short. Also consider any future expansion,
function of the equipment, vandalism, etc.
! Physically mount all the equipment in the desired locations.
! Connect a power source to the H-219X. This power source should be a 12 Volt power
source, but not to exceed 16 Volts. Use 18 gauge wires or heavier for a standard modem
application, if the RF radio is used then use 16 gauge or larger wires for the power .
! Connect the phone line to the phone line connection of the H-2191 using a standard RJ11
connector. For the H-2192, cell phone sites, install and connect the antenna.
! For sites using the RF radio, install the radio and make appropriate connections as
H-219X
Installation 2-5